My 5 point rx7 roll bar pictures

My rx7 infiltrated the MSCA gang for a roll cage installation. They normally don't mess with rice burners.

Steve and Chris (the twins, or stevo and lorenzo or c-lo or '90 Notch', they have many names) did a great job. Basically started on thursday and car was ready following Wednesday and that was over the memorial weekend.

Looks like they took their time and made it nice and safe, extra gussets and an extra brace on the drivers side bar on the floor because their was some flex on the drivers floor. Welds look great and they welded to strong areas of the car. They worked around my rear storage bins.

Drivers side bar is a swing out and that adds some complexity but that looks nice too, swing out bar has a metal pin sleeve welded in the tube for the release pin and the bar is capped for added strength.

Are you happy with that Comp swing out kit? I'm wanting the CAC kit, but at $130 a side, that's a bit of money.

Told ya it would be Super nice and fast turn around time.

Top notch Lorenzo work again!!!! Looking good!

Seems like they are go to guys in Cedar Rapids, love all of the work they have put out.

Sweet. I always wanted to cage my fc but never had any reason to.

Looks good man. Can't.wait to see it running flat out with some tires under it! I didn't get to see it run its best last year.

Lorenzooo and Stevo always do top notch work...